Blog - Vapefly Alberich II 2 MTL RTA Review

Home
Blog
Vapefly Alberich II 2 MTL RTA Review

Product was successfully added to your shopping cart.

Vapefly Alberich II 2 MTL RTA Review

Jul 20, 2023 By Insane

The latest creation of the VapeFly company is dedicated especially to fans of the MTL method. The atomizer is inspired by high-end productions.
The design of the Alberich 2 has been completely reworked in relation to its precursor.
This time, VapeFly opted for the upper airflow to limit any leaks as much as possible.

Technical Specifications:
Diameter: 23mm
Height: 59mm
Capacity: 4ml
Weight: 73g
Top Filling System (Quarter Turn)
The base for a single heater
Top airflow

The atomizer uses the top airflow, which guarantees us a significant minimization of leaks.
However, due to this fact and the desire to obtain the largest capacity, the atomizer is not the smallest.
Together with the attached mouthpiece, it gives the impression of being really high, which with less power may look a bit comical. Refilling is done from the top of the atomizer, just a quarter of a turn of the top of the atomizer. However, nothing stands in the way of unscrewing the base of the atomizer and refueling from the bottom, as I am used to doing. Alberich 2 holds a little over 4 ml of liquid, taking into account the specificity of the atomizer, this is a very satisfactory result.

The airflow is controlled only with the included inserts. I liked the one with a diameter of 1 mm the most.
In my opinion, this is where the real MTL begins.
I must admit that I really miss an ordinary ring here, which could be freely set to suit myself and my own preferences. The atomizer is available in three standard colors: silver, black and metallic black. Unfortunately, the recently extremely popular powder pink is missing here. Arming the Alberich 2 seems trivial at first glance, but I have to admit it sadly. I can't remember the last time I had to stretch myself so much to set the heater properly. Fortunately, it got a little easier with each subsequent attempt.

In order to make screwing the heater a bit easier and so that it is immediately perfectly in the middle, I recommend slightly skewing the legs of our spiral.
It is also best to screw the heater so that the legs are on the right side of the screws, due to their threading.
If we screw it on the left side, then when tightening the heater, we will push it out.
Cutting the carrier should not be a problem for anyone, just cut the cotton flush with the edges of the atomizer. Alberich 2 likes cotton very much and we should not be afraid of its excess. When the carrier is not enough, we will start to suck the liquid as if through a straw.

Alberich 2 is undoubtedly an interesting MTL atomizer with top airflow. I can't quite understand why it was deprived of smooth airflow regulation. Probably due to the High-End trend, let's hope this trend ends as soon as possible - because we all lose on it.

Despite not fully thought-out solutions, the atomizer from VapeFly is an interesting item for novelty seekers and fans of clouding with the MTL method.
Alberich 2 will guarantee us no leaks (unless we try very hard) while maintaining the right taste.
Which in the case of top airflow atomizers is not at all obvious.

Kit Contents: